Pm Services For Grilles And Gates:

Check general operation of system

Assess condition of driveway

Inspect structural state of gate support

Inspect cable ducts and access where possible

Inspect condition of gates

Check gate alignment and ground clearance

Inspect general condition of hinges, gate stops and other gate furniture

Grease hinges

Inspect operators for condition, damage, wear etc.

Check operator fixings, brackets and geometry

Assess performance of operators and clutch settings

Bleed and top-up oil

Pressure test and adjustment – open and close

Check manual release and locking performance

Check protection of electrical connections to operators

Assess system usage levels

Assess Logic, Run, Pause, Leaf Delay and Over-run times

Carry out electrical inspection and earth insulation test on motors and their cables

Inspect isolation and protection of mains power supply

Check if RCD is present

Check electrical connections, terminations and protection

Check earthing termination

Check condition and operation of all control equipment

Check sealing of control box

Check sealing of Audio Link, photocells and other control equipment

Clean Audio Entry panel

Clean out foundation boxes and check drainage for under gate operators

Check and if required, change batteries on Safety Edge and Photocell Transmitters

Highlight any areas of concern and provide appropriate recommendations

Check, affix and date service sticker